Pair of Back Cultivator Bar Mounts for Farmall 140, 130, Super A, 100 Tractors Also referred to as a

Also referred to as a distributor locking clamp or distributor hold down clamp

and Super A Tractors

This spring is used for BOTH brakes and clutch on the above tractors

The belt drive output shaft is 1-1/8" inch diameter and 6 spine where as the standard PTO 540 RPM output shaft is 1-3/8" inch diameter and 6 spline

New Swinging Drawbar Mounting Kit for International and IH Farmall Cub Tractors

Pair of Back Cultivator Bar Mounts for Farmall 140, 130, Super A, 100 Tractors Also referred to as aPair of Back Cultivator Bar Mounts for International and IH Farmall 140, 130, Super A, and 100 Tractors. For above listed tractors WITHOUT 1 Point Fast Hitch. Cultivator mount has a weld shown in photo number 3. They are in usable condition. Case IH Back Cultivator Bar Mounts part numbers 1929BA and 1930BA (Left and Right Mounting Brackets). These are the rear cultivator mounting brackets that bolt to the side of the final drives and the rear