SKU: 5791598726
Ships within 48 hours · Estimated delivery Aug 24 - Aug 29
The can present sensor is used on all EVO and WG8/10 systems
Corrosion resistance class (CRC): 1 - Low corrosion stress
This flow control fitting is used to control the speed of the cylinder's extend and retract motions
12 bit resolution
the mounts raise the equipment off the floor for easier cleaning and inspection
Can Present Sensor with Quick Connect electrical The can present sensor isThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.
US$ 35.00
US$ 35.00
US$ 34.95
US$ 1309.50
US$ 1579.50
US$ 1309.50
US$ 24.95
US$ 851.17
US$ 1737.50
US$ 19.99
US$ 27.99
US$ 34.95
